SATO CL4NX Plus - [Sensor Type]; [Micro Label Print Mode]

211
[Sensor Type]
Set the sensor type for detecting the media.
The options are as follows:
None
Disable the media sensor.
Gap
Select when using gap type media. Use the transmissive type sensor.
I-Mark
Select when using I-mark type media. Use the reflective type sensor.
• If you have selected [Tear-Off], [Dispenser], or [Cut & Print] in the [Print Mode] menu,
only [Gap] and [I-Mark] will be available.
• If you have selected [Linerless] in the [Print Mode] menu, only [None] and [I-Mark] will
be available.
[Micro Label Print Mode]