SATO CL4NX Plus - Page 292

[Network]
292
[ENQ Reply Delay]
Set the period to delay status reply to status request ENQ.
The target interfaces are LAN and Wireless LAN.
The target statuses are Status3, Status4 ENQ reply, and Status5.
The setting range is from 0 to 9999 ms.
• Normally, keep this setting at the default value.
[Status4 Cyclic Response]
Set the interval for the cyclic status response.
The target interfaces are LAN and Wireless LAN.
The target status is Status4 reply cycle.
The setting range is from 100 to 999 ms.