Doing a Test Read with the Barcode Checker
632
7.
Press the / buttons to select [Reading Test], and then press the
button.
8. Set a label with barcodes within the scanning range of the barcode checker.
9.
Press the button to start reading the barcodes.
If reading is successful, the barcode type and data read are displayed on the screen. Only the first
23 bytes of data are displayed.
If reading is unsuccessful, or the displayed results of the read are not correct, adjust the position
of the barcode checker by using the barcode checker stand. For details on how to use the barcode
checker stand, refer to the Barcode Checker Stand Kit Installation Manual that came with the
barcode checker stand kit.
• If the product cannot detect the barcode checker, check if the operational settings for
the barcode checker are appropriate.
To Next Page
Loading...
