63 22 726 D3561
D3561.201.01.03.02 05.2012
165
Sirona Dental Systems GmbH 4 Operation
Operating Instructions SINIUS / SINIUS CS 4.13 Configuration of the treatment center (setup)
båÖäáëÜ
4.13.5 Configure instruments
Configure instruments
➢ Touch the
Instruments
key in the setup program.
The sub-screen opens.
4.13.5.1
Preselecting quick setting keys with SaveMode/with DropMode or
function levels
Preselect ing quick setting keys with SaveM ode/with DropM ode or function levels
Settings can be made in the instrument programs using either the quick
setting keys (1...100) or two freely programmable function levels (E1, E2).
For more information, please refer to "Quick setting keys and function
levels" [ → 82].
When using the quick setting keys, you can choose one of two options for
saving the settings you made in the instrument program:
● SaveMode – The
Memory
key is displayed in the instrument
programs:
The settings made in the instrument program will be saved after the
instrument is placed in its holder only if the Memory key was pressed
and held beforehand (> 2 s).
● DropMode –
Memory
key hidden in Instrument programs:
When the instrument is deposited, the settings made in the
Instrument program will automatically be saved.
One of the following presettings can be selected:
● Field 1: Quick setting keys with SaveMode
● Field 2: Quick setting keys with DropMode
● Field 3: Function levels
➢ Touch the
Select memory type
key.
The selected field is highlighted orange.
4.13.5.2
Switching afterblow on/off
Switching a fterblow on/off
After an instrument is deposited in its holder, the cooling spray remaining
in the instrument head or in the tip of the instrument is automatically blown
out by a brief activation of the chip blower (air puff).
➢ Touch the
Afterblow
key.
If the key is highlighted orange, the afterblow function is
activated.
To Next Page
Loading...
