63 22 726 D3561
46 D3561.201.01.03.02 05.2012
4 Operation Sirona Dental Systems GmbH
4.1 Starting up the treatment center Operating Instructions SINIUS / SINIUS CS
4.1.2.2
Main switch
Main switch
Switching the treatment center on
The main switch switches the treatment center from Standby mode to
operational readiness.
Following switch-on, the operating system is booted and an automatic
self-test is performed.
✔ The power switch is turned on.
➢ Press the main switch on the dentist element.
The LED of the main switch lights up on the dentist element.
The treatment center powers up and establishes operational
readiness.
If the next maintenance call is due in less than 42 days or the
maintenance deadline has already been exceeded, a message appears
on the touchscreen. For more information, please refer to "Inspection and
maintenance" [ → 217].
Switching the treatment center to the Standby mode
with internal PC
On completing your work, you should switch the treatment center off with
the main switch on the dentist element both for safety reasons and to
reduce its power consumption. Pressing the main switch turns the air and
water supply as well as all electronic components off. Only the standby
circuit is still supplied with voltage. Providing there are no subsequent
devices operating on the external device connection and the treatment
center is not equipped with an internal PC, thein standby mode is approx.
3 W.
➢ Press and hold the main switch on the dentist element until an
acoustic signal sounds. Then release the key.
The treatment center then shuts down and switches itself to the
Standby mode.
The LED of the main switch goes out on the dentist element.
4.1.3 Selecting a user profile
Selecting a user profile
The treatment center enables you to manage up to six user profiles.
Multiple users can operate the treatment center without having to do
without their own individual treatment and operation related settings.
The following is stored in the user profiles:
● Creation of chair programs, see "Creating chair programs and shock
positioning" [ → 72]
● Configurations in the Setup programs, see "Configuration of the
treatment center (Setup)" [ → 157]
● Settings in the instrument programs, see "Saving the instrument
settings" [ → 84]
● Configuration of the SIVISION screen for PC control. The
configuration is saved in the PC application SIUCOM plus that is
installed on the PC.
To Next Page
Loading...
