Sirona Sinius - Timer Function

63 22 726 D3561
D3561.201.01.03.02 05.2012
77
Sirona Dental Systems GmbH 4 Operation
Operating Instructions SINIUS / SINIUS CS 4.5 Dentist element
båÖäáëÜ
It is not possible:
● to switch to the instrument program or the sub-screen of an
instrument when no instrument has been removed
● to switch to the SIVISION program when the PC connection is turned
off or has not been configured
You can change from sub-screens and settings screens to a main
program by touching one of the three keys in the Start program without
instrument functions.
4.5.4.3
Timer function
Timer function
A set time can be counted down to zero with the timer function. Four
timers can be preset. A time loop (automatic restart of the countdown)
and an acoustic signal (when the set time has expired) can be added to
each timer.
Presetting the timers
The maximum time setting is 9 minutes and 30 seconds.
1. Press and hold the
Timer fixed key on the dentist element (> 2 s).
 The
Timer Function settings screen is displayed on the
touchscreen.
2. Select one of the four timers to change its presetting. To do this,
touch one of the selection keys along the bottom edge of the settings
screen.
 The selected timer is highlighted orange.
3. Use the
– and + keys to set the required time.
Increments:
From 0:05 to 1:00 = 5 s steps
From 1:00 to 3:00 = 10 s steps
From 3:00 to 9:30 = 30 s steps
4. Select whether the time loop and the acoustic signal should be
activated/deactivated for the selected timer. Touch the
Time Loop
and or
Acoustic Signal key.
 If a function is switched on, the corresponding key is highlighted
orange.
5. Select another timer for adjustment or close the settings screen with
the
Return key.
 All settings are automatically saved when the screen is closed.