Sirona Sinius - Operating Light; Shock Positioning

63 22 726 D3561
78 D3561.201.01.03.02 05.2012
4 Operation Sirona Dental Systems GmbH
4.5 Dentist element Operating Instructions SINIUS / SINIUS CS
Starting the timers
1. Press the Timer fixed key briefly.
 The last timer used is started immediately. The set and elapsed
time are displayed in the footer. The
Timer function screen
remains visible.
2. If you wish to use a different timer, touch one of the timers at the lower
edge of the screen.
 If the expired time is less than the new setting of the timer, the
new time will be shown in the footer. The previously started timer
will not be reset to zero.
3. Optionally: You can switch the time loop and/or acoustic signal on/off
while the timer is counting down. Touch the
Time Loop and/or the
Acoustic Signal key.
 If a function is switched on, the corresponding key is highlighted
orange.
Stopping/resetting the timer
When the Timer function screen is deactivated, the timer can also be
stopped by pressing the
Timer fixed key. If the screen is activated, the
timer will be reset to zero.
4.5.4.4
Shock positioning
Shock positioning
Immediately moves the patient chair to a position for shock positioning of
the patient.
SINIUS reference
To program the position of the shock positioning function, see "Creating
chair programs and shock positioning" [ → 72]
4.5.4.5
Operating light
Operating light
Switching the operating light on/off
The operating light is always switched on at the set brightness level, see
"Adjusting the brightness" (below).
➢ Briefly press the
Operating Light fixed key.
 If the operating light is switched on, the LED of the fixed key lights
up on the dentist and assistant elements.
Setting the sensor control and brightness of the LEDview
Setting the sensor control and brightness of the LEDview
A contactless switch is installed at the bottom of the LEDview operating
lights. The operating lights can be switched on/off by a hand movement
or changed to the Composite function. See "LEDview Operating
Instructions".
The NoTouch sensor control can be switched on and off via the treatment
center touchscreen. Furthermore, the distance from which the
contactless switch should react to movements can be adjusted.