63 22 726 D3561
72 D3561.201.01.03.02 05.2012
4 Operation Sirona Dental Systems GmbH
4.4 Patient chair Operating Instructions SINIUS / SINIUS CS
4.4.9 Creating chair and shock positioning programs
Creating chair and shock positioning programs
Chair programs
The four chair programs preset in the factory:
● Mouth rinsing position S
● Entry/exit position 0
●1 and 2
can be individually programmed for each of the six user profiles (A to F).
✔ The
Start program
is displayed on the touchscreen.
1. Move the patient chair to the required treatment position; see "Moving
the chair manually" [ → 70].
2. If a motor-driven headrest is installed: Tilt the headrest to the required
treatment position; see "Inclining the headrest" [ → 65].
3. Switch the operating light on or off (this will be included in the
program), see “Operating light” [ → 142].
4. Press and hold the desired program key (S, 0, 1, 2) (> 2 s).
An audible signal sounds. Your settings are now stored under the
desired program key.
Tip: Chair programs S and 0 can also be programmed on the assistant
element side.
Shock positioning
When the
Shock positioning
key is pressed, the patient chair immediately
moves to a position suitable for shock positioning of the patient.
The shock positioning position preset at the factory can be
reprogrammed.
1. Move the patient chair to the desired position.
2. Press and hold the
Shock positioning
key (> 2 s).
Patient chair, shock positioning
WARNING
Program this key exclusively for shock positioning the patient, never use
as a treatment position.
To Next Page
Loading...
