FRONT DRIVE SHAFT (G10/M13 ENGINES) 4A-17
Center Shaft and Center Bearing Support Dis-
assembly and Assembly (2WD Model with
M13 Engine)
Disassembly
1) For M/T model, go to the next step. For A/T model, remove
wheel side oil seal and circlip from center bearing support
bracket (3).
2) Using hydraulic press (1), draw out center shaft (2) from cen-
ter shaft support bearing.
3) Remove oil seals from center bearing support bracket (3).
4) Remove bearing support circlip(s) (1) by using special tool.
Special tool
(A): 09900-06108
5) Remove center shaft support bearing from center bearing
support bracket.
Assembly
Install center shaft by reversing removal procedure and noting fol-
lowing points
• When installing circlips (1), make sure that it fits in circlip
groove in center bearing support bracket (2) securely as
shown.
To Next Page
Loading...
