PARKING AND REAR BRAKE 5C-9
6) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (b): 95 N·m (9.5 kg-m, 69.0 lb-ft)
7) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
Brake Back Plate (for 2WD Model)
Removal
1) Remove brake drum referring to step 1) to 5) of “Brake Drum
Removal” in this section.
2) Remove brake shoe referring to step 2) to 4) of “Brake Shoe
Removal” in this section.
3) Remove wheel cylinder referring to step 3) to 4) of “Wheel
Cylinder Removal” in this section.
4) Remove parking brake cable securing clip (1) and discon-
nect brake cable (2) from brake back plate (3).
5) Remove brake back plate (1) from rear axle.
To Next Page
Loading...
