6A2-92 ENGINE MECHANICAL (M13 ENGINE)
Required Service Material
Tightening Torque Specification
Material
Recommended SUZUKI product
(Part Number)
Use
Sealant SUZUKI BOND NO. 1207F
(99000-31250)
• To apply to mating surfaces of cylinder block and oil
pan.
• To apply to mating surfaces of cylinder block and
timing chain cover.
• To apply to sealing surfaces of cylinder head cover.
• To apply to mating surfaces to rear oil seal housing.
SUZUKI BOND NO. 1207B
(99000-31140)
• To apply to mating surface of cylinder block, cylin-
der head and timing chain cover.
SUZUKI BOND NO. 1215
(99000-31110)
• To apply to the thread of the bolt of water outlet
pipe.
Fastening part
Tightening torque
N•m kg-m lb-ft
Oil pressure switch 14 1.4 10.5
Camshaft housing bolt
(for tightening of special tool)
11 1.1 8.0
Camshaft housing bolt Tighten 11 N·m (1.1 kg-m, 8.0 lb-ft) by the specified procedure.
Cylinder head cover bolt Tighten 5.0 N·m (0.5 kg-m, 3.5 lb-ft), 7.5 N·m (0.75 kg-m, 5.5 lb-ft) by
the specified procedure.
Intake manifold bolt and nut 25 2.5 18.0
Throttle body mounting bolt 25 2.5 18.0
MAF sensor bolt 2.5 0.25 2.0
VSV bracket bolt 5 0.5 3.5
Exhaust manifold bolt and nut 50 5.0 36.5
Exhaust pipe No.1 bolt 50 5.0 36.5
Exhaust manifold stiffener bolt 50 5.0 36.5
Exhaust pipe No.2 bolt 43 4.3 31.5
Exhaust oxygen sensor 45 4.5 32.5
Oil pump strainer bolt 11 1.1 8.0
Oil pump strainer bracket bolt 11 1.1 8.0
Oil pan bolt and nut 11 1.1 8.0
Oil pan drain plug bolt 50 5.0 36.5
Timing chain cover mounting bolt 25 2.5 18.0
Timing chain cover mounting nut 25 2.5 18.0
Crank shaft pulley bolt 150 15.0 108.5
Oil pump rotor plate bolt 11 1.1 8.0
Timing chain guide bolt 11 1.1 8.0
Tensioner adjuster bolt 11 1.1 8.0
Venturi plug 5 0.5 3.5
Cylinder head bolt for M8 25 2.5 18.0
To Next Page
Loading...
