AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-103
Operation Check
Shift solenoid valve-A (No.1), -B (No.2) and TCC solenoid
valve
• Check that solenoid valve (1) actuate with click sound when
battery voltage is conducted.
• When solenoid valve (1) is connected to battery (2), confirm
that solenoid valve is close condition by blowing air (50 – 200
kPa, 0.5 – 2.0 kg/cm
2
, 7 – 28.5 psi) into solenoid valve as
shown in the figure.
• When solenoid valve (1) is not connected to battery (2), con-
firm that solenoid valve is open condition by blowing air (50 –
200 kPa, 0.5 – 2.0 kg/cm
2
, 7 – 28.5 psi) into solenoid valve
as shown in the figure.
CAUTION:
Do not insert air gun against strainer installed on inlet of
solenoid valve too deeply, when blowing air into solenoid
valve. If not, the strainer will be damaged.
NOTE:
Do not fail to inspect with air to prevent mistaken check-
ing because return spring for valve is not installed into
solenoid valve.
To Next Page
Loading...
