7D-6 TRANSFER
4) Tighten transfer to engine stiffener bolts to specified torque.
Tightening torque
Transfer to engine stiffener No.1 bolt
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
Transfer to engine stiffener No.2 bolt
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
5) Tighten transfer to transaxle stiffener bolts (1) to specified
torque.
Tightening torque
Transfer to transaxle stiffener bolt
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
• Install exhaust No.1 pipe referring to “Exhaust System Com-
ponents” in Section 6K2.
• Install right side drive shaft referring to “Drive Shaft Removal
and Installation” in Section 4A.
• Install propeller shaft referring to “Propeller Shaft Removal
and Installation” in Section 4B.
• Fill transfer with transfer oil referring to “Oil Change” in Sec-
tion 7D of the Service Manual mentioned in the “FORE-
WORD” of this manual.
• Fill transaxle with transaxle oil referring to “Manual Transaxle
Oil Change” in Section 7A2.
Tightening Torque Specification
2. Transfer
3. Stiffener
4. Transaxle
Fastening part
Tightening torque
N•m kg-m lb-ft
Transfer oil level/filler and drain plug 21 2.1 15.5
Flange nut 100 – 300 10.0 – 30.0 72.5 – 217.0
Transfer case bolt 23 2.3 17.0
Transfer output retainer bolt 50 5.0 36.5
Transfer rear mounting bracket bolt 55 5.5 40.0
Transfer rear mounting bracket nut 55 5.5 40.0
Transfer mounting bolt 55 5.5 40.0
Transfer rear mounting bracket No.2 bolt 55 5.5 40.0
Transfer to engine stiffener No.1 bolt 50 5.0 36.5
Transfer to engine stiffener No.2 bolt 23 2.3 17.0
Bevel gear nut 150 15.0 108.5
Transfer to transaxle stiffener bolt 50 5.0 36.5
To Next Page
Loading...
