Thermo Scientific Evolution 201 - Page 317

19
TPS-1500W Sealed Peltier Recirculator
Thermo Scientific Evolution 200 Series User Guide 303
Alarm Mode
Preinstallation
Installation
Maintenance
Troubleshooting
Normal Mode
Button Functions
•Press the left (Menu) button to go to the Main Menu page.
•Press and hold the center (Off) button for one to two seconds to return to Stand-By
Mode.
•Press the right (Change) button to go to the Change Set Point page.
Y Changing the set temperature
1. From the main Normal Mode page, press the Change button to highlight Set
Te m p e r a t u r e .
The Change Set Point page appears with down and up arrows above the Left and Center
buttons.
2. Use the down and up arrow buttons to change the set temperature.
Contents
• Button Functions
• Parameters Menu
• Configure Menu
• Diagnostic Menu
Table 2. Normal Mode functions
Page Display Description Left button Center button Right button
Main Menu Parameter User Parameters Scroll Select Exit
Configure Configuration Parameters Scroll Up Exit
Diagnostic Diagnostic Values Down Up Exit
Change Set
Point
Flashes selected
parameter
Change Temperature Set Point Down Up Change