09/2007
4-18
Phaser 8860/8860MFP Service Manual
REP 2.0.2
Initial Issue
Repairs and Adjustments
Figure 3 Releasing the Printhead Tilt Spring.
10. Pull the X-Axis Bias Spring and Hook out slightly, and then rotate downward to allow it to
rest in detents provided on the frame. See Figure 4.
Figure 4 X-Axis Bias Spring Hook
11. Disconnect the Air Hose from the Purge Pump.
12. Remove the left and right Printhead Restraints. To remove the restraints, remove 1 (plas-
tic, T-20) screw that secures each restraint, and then shift the restraint inwards toward the
Printhead while lifting toward the rear of the printer.
To Next Page
Loading...
