Xerox VersaLink B7035

April 2017
2-501
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
103-310 to 103-313, 103-314
Status Indicator RAPs
Launch Issue
103-310 to 103-313 Hybrid Water Mark RAP
103-310 The secure watermark kit cannot be made available because the hybrid watermark
detection hardware is not installed.
103-311 The secure watermark Kit is not enabled.
103-312 The secure watermark kit cannot be made available because the hybrid watermark
detection hardware for document side 2 is not installed.
103-313 The secure watermark kit did not become available because of insufficient IISS exten-
sion memory.
Procedure
For information only. No service action necessary.
103-314 Prohibited Originals RAP
103-314 Possible prohibited originals (system fail).
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Initialise the hard disk, refer to dC355 Image Disk Diagnostics.
4. Reload the software, GP 4.
5. If the fault persists, install new ESS PWB, PL 3.10 Item 6.