Electrical component and wire harness routing
5-2
1. Starter motor
2. Oil pressure switch
3. Ignition coil #1, #4
4. Ignition coil #2, #3
5. Rectifier/regulator
6. PTT relay
7. Water detection switch
8. Diode
9. YDIS coupler
10. Reprogramming connector
11. Lighting coil lead
12. PTT relay lead
13. Ignition coil lead
14. Wire harness
15. PTT motor lead (Blue)
16. PTT motor lead (Green)
17. Rectifier/regulator lead
18. Magnet switch lead
19. Starter motor lead
20. Joint connector 1
21. Joint connector 2
A. Align the tape markings for cylinder iden-
tification on the spark plug wires with the
br
acket end, and then install the spark
plug wires.
B. Fasten the spark plug wires of the igni-
tion coils #2 and #4 using the clamp.
When doing so, make sure that the wires
do not
interfere with each other.
C. Fasten the spark plug wires of the igni-
tion coils #3 and #4 using the clamp.
When doing so, make sure that the wires
do not
interfere with each other.
D. Tiller handle model
E. Remote control model
F. Install the terminals in the direction
sho
wn in the illustration.
Make sure that the terminals do not move
after insta
llation.
G. Make sure that the ground terminal con-
tacts the detent, and then secure it.
H. Make sure that the lighting coil lead has
no slac
k.
I. Tighten the plastic tie so that it has no
sla
ck.
Make sure the plastic tie is attached in
the direction sho
wn in the figure, and do
not cut off the end of the plastic tie.
To Next Page
