Electrical component and wire harness routing
5-12
1. Engine start switch coupler
2. Extension wire harness
3. Alert indicator harness
4. Grommet
5. Engine start switch
6. Engine shut-off switch
7. Alert buzzer
8. Neutral switch
9. PTT switch
10. Alert indicator
A. Run the leads (blue and black) under the
cont
rol link assembly.
B. Run the neutral switch leads (brown)
under t
he buzzer.
C. Bend the extension wire harness “2”, and
then conne
ct the harness coupler. This
harness bending position must be 10.0
mm (0.39 in) or more away from the
engine start switch coupler “1”. The bend
radius should be 10.0 mm (0.39 in) or
more.
D. Align the tape ends of the extension wire
har
ness “2” and the alert indicator har-
ness “3” with the end of the grommet “4”.
E. Install the engine start switch “5” with the
hole
of the switch facing upward.
To Next Page
