9-40
SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
“P0201” Injector #1: malfunction in injector #1.
Able
(depending
on the num-
ber of faulty
cylinders)
Able
(depending
on the num-
ber of faulty
cylinders)
D36
“P0202” Injector #2: malfunction in injector #2.
Able
(depending
on the num-
ber of faulty
cylinders)
Able
(depending
on the num-
ber of faulty
cylinders)
D37
“P0335”
Crankshaft position sensor: no normal
signals are received from the crankshaft
position sensor.
Unable Unable —
“P0351”
Ignition coil: open or short circuit detect-
ed in the primary lead of the ignition coil.
Unable Unable D30
“P0480”
Radiator fan motor relay: open or short
circuit detected.
Able Able D51
“P0500”
Rear wheel sensor: no normal signals
are received from the rear wheel sensor.
Able Able D07
“P0507” Engine idling speed is too high. Able Able D67
“P0560,
P0563”
• [P0560] Charging voltage is abnormal.
• [P0563] Vehicle system power voltage
out of range.
Able Able —
“P0564”
• Cruise control setting switch “RES+”:
open or short circuit is detected.
• Cruise control setting switch “SET-”:
open or short circuit is detected.
Able Able D80, D81
“P056C”
• Front brake light switch: open or short
circuit is detected.
• Rear brake light switch: open or short
circuit is detected.
Able Able D82, D83
“P0601”
Internal malfunction in ECU. (When this
malfunction is detected in the ECU, the
DTC might not appear on the tool dis-
play.)
Unable Unable —
“P0606”
Internal malfunction in ECU. (When this
malfunction is detected in the ECU, the
DTC might not appear on the tool dis-
play.)
Able/Unable Able/Unable —
“P062F”
EEPROM DTC: an error is detected
while reading or writing on EEPROM.
Able/Unable Able/Unable D60
“P0638”
YCC-T drive system: malfunction detect-
ed.
Able/Unable Able/Unable —
“P0657”
Fuel system voltage: incorrect voltage
supplied to the injector and fuel pump.
Able Able D09, D50
DTC Symptom
Fail-safe system
Diagnostic
code
Starting the
engine
Driving the
vehicle
To Next Page
Loading...
Need help?
General
