Chapter 29 Secure Policy
ZyWALL Series CLI Reference Guide
231
The following command displays the default IPv6 firewall rule that applies to the WAN to Zyxel Device
packet direction. The firewall rule number is in the rule’s priority number in the global rule list.
The following commands activate secure-policy backup, displays its status and then shows where to
fond the configuration files. Filenames beginning with autoback are automatic configuration files
created when new firmware is uploaded. backup-2017-12-13-13-34-49.conf is the name of the
Router(config)# show secure-policy6 WAN ZyWALL
secure-policy rule: 1
name: Device_Default_Allow_Service
description:
user: any, schedule: none
from: any, to: ZyWALL
source IP: any, source port: any
destination IP: any, service: Default_Allow_v6_any_to_ZyWALL
log: no, action: allow, status: yes
content-filter profile: none
enable: no, log: by-profile
anti-spam profile: none
enable: no, log: by-profile
anti-virus profile: none
enable: no, log: by-profile
idp profile: none
enable: no, log: by-profile
ssl-inspection profile: none
enable: no, log: by-profile
app-patrol profile: none
enable: no, log: by-profile
secure-policy rule: 11
name: WAN_to_Device
description:
user: any, schedule: none
from: WAN, to: ZyWALL
source IP: any, source port: any
destination IP: any, service: Default_Allow_v6_WAN_To_ZyWALL
log: no, action: allow, status: yes
content-filter profile: none
enable: no, log: by-profile
anti-spam profile: none
enable: no, log: by-profile
anti-virus profile: none
enable: no, log: by-profile
idp profile: none
enable: no, log: by-profile
ssl-inspection profile: none
enable: no, log: by-profile
app-patrol profile: none
enable: no, log: by-profile
To Next Page
Loading...
