Chapter 30 Cloud CNM
ZyWALL Series CLI Reference Guide
248
You must be in configuration mode (configure terminal) to use the indented commands shown
below.
Table 126 Command Summary: Cloud CNM SecuReporter
COMMAND DESCRIPTION
secu-reporter activate {no |
yes}
Use yes to send security-related logs to the SecuReporter portal. Use no
to disable SecuReporter logging.
SecuReporter must be enabled to collect and analyze logs from this
Zyxel Device.
• You must read and accept the General Data Protection Regulation
(GDPR) privacy policy by enabling SecuReporter in the Web
Configurator before you can enable it by using the CLI.
• SecuReporter is enabled by default if you have activated a
SecuReporter Standard license,
• SecuReporter is disabled by default if you have a SecuReporter Trial
license.
• You cannot enable SecuReporter if you do not have a
SecuReporter license.
show service-register status
secu-reporter
Displays current Cloud CNM SecuReporter registration status at
myZyxel.
show secu-reporter status
Displays current Cloud CNM SecuReporter status on this Zyxel Device.
secu-reporter traffic-log
{activate | deactivate}
Use activate to send traffic logs to the SecuReporter portal for
application usage analysis via this Zyxel Device. This may cause an
increase in traffic to SecuReporter from this Zyxel Device. Use
deactivate to disable sending traffic logs if it impacts Zyxel Device
performance.
secu-reporter upload-filesize
<1..10>
A temporary log file is uploaded to the SecuReporter security analytics
portal when it meets the size set here (in megabytes) or the interval
defined in the following field. 10 MB is the default. Set it to a smaller
number for more frequent uploads.
secu-reporter upload-interval
<60..600>
A temporary log file is uploaded to the SecuReporter security analytics
portal at the interval defined here or when it meets the size setin the
previous field. 300 seconds is the default. Set it to a smaller number for
more frequent uploads.
secu-reporter adp
{activate|deactivate}
The activate command will have the Zyxel Device send ADP logs to
SecuReporter for analysis and trend spotting.
secu-reporter anti-spam
{activate|deactivate}
The activate command will have the Zyxel Device send anti-spam
logs to SecuReporter for analysis and trend spotting.
secu-reporter anti-virus
{activate|deactivate}
The activate command will have the Zyxel Device send anti-virus logs
to SecuReporter for analysis and trend spotting.
secu-reporter ap-managed
{activate|deactivate}
The activate command will have the Zyxel Device send logs of the
APs connected to the Zyxel Device to SecuReporter for analysis and
trend spotting.
secu-reporter app-patrol
{activate|deactivate}
The activate command will have the Zyxel Device send application
patrol logs to SecuReporter for analysis and trend spotting.
secu-reporter content-filter
{activate|deactivate}
The activate command will have the Zyxel Device send content
filtering and URL Threat filtering logs to SecuReporter for analysis and
trend spotting.
secu-reporter idp
{activate|deactivate}
The activate command will have the Zyxel Device send IDP logs to
SecuReporter for analysis and trend spotting.
secu-reporter interface-
statistics {activate|deactivate}
The activate command will have the Zyxel Device send logs of
interface statistics to SecuReporter for analysis and trend spotting.
To Next Page
Loading...
