Chapter 33 IPSec VPN
ZyWALL Series CLI Reference Guide
283
[no] configuration-payload-provide
{first-dns IPv6|second-dns IPv6}
Sets configuration payload address dns server. The no
command disables it
[no] narrowed
Enables policy narrowed. The no command disables it.
[no] protocol gre
Enables GRE over IPSec to allow traffic using the
Generic Routing Encapsulation (GRE) tunneling
protocol through an IPSec tunnel. The no protocol
command disables it.
mode-config activate
Allows the IPSec VPN client to receive an IP address,
DNS and WINS information from the Zyxel Device when
the scenario is Remote Access (Server Role) and VPN
Gateway uses IKEv1. remote-access-server allows
incoming connections from IPSec VPN clients with
dynamic IP addresses.
mode-config address- profile_name
Sets the IP address to be included in the VPN setup
data.
profile_name: an address or address group object
[no] mode-config {first-dns | second-
dns}
Specifies the DNS server IP address to assign to the
remote users. The second-dns server's IP address is
checked if first-dns is unavailable. The no
command removes the setting.
Table 148 crypto Commands: IPSec SAs (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
