Chapter 48 Device HA
ZyWALL Series CLI Reference Guide
434
[no] device-ha ap-mode master sync
authentication password password
This is for a master Zyxel Device. It specifies the password to require from
synchronizing backup Zyxel Devices. Every router in the virtual router must use
the same password. The
no command sets the password setting to blank
(which means no backups can synchronize with this master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-), and
#%^*={}:,.~ characters.
[no] device-ha ap-mode backup sync
authentication password password
Sets the password the backup Zyxel Device uses when synchronizing with the
master. The
no command sets the password setting to blank (which means this
backup Zyxel Device cannot synchronize with the master).
password: Use 4-63 alphanumeric characters, underscores (_), dashes (-), and
#%^*={}:,.~ characters.
[no] device-ha ap-mode backup sync
auto
Turns on automatic synchronization according to the interval you specify in
device-ha ap-mode backup sync interval. The first synchronization begins
after the specified interval (not immediately).
[no] device-ha ap-mode backup sync
interval <5..1440>
When you use automatic synchronization, this sets how often (in minutes) the
Zyxel Device synchronizes with the master.
[no] device-ha ap-mode backup sync
from master_address port port
Sets the address of the master Zyxel Device with which this backup Zyxel
Device is to synchronize.
master_address: The master Zyxel Device’s IP address or fully-qualified
domain name (FQDN).
port: The master Zyxel Device’s FTP port number.
device-ha ap-mode backup sync now
Synchronize now.
show device-ha ap-mode interfaces
Displays the device HA AP mode interface settings and status.
show device-ha ap-mode next-sync-
time
Displays the next time and date (in hh:mm yyyy-mm-dd format) the Zyxel
Device will synchronize with the master.
show device-ha ap-mode status
Displays the Zyxel Device’s key device HA settings.
show device-ha ap-mode master sync
Displays the master Zyxel Device’s synchronization settings.
show device-ha ap-mode backup sync
Displays the backup Zyxel Device’s synchronization settings.
show device-ha ap-mode backup sync
status
Displays the backup Zyxel Device’s current synchronization status.
show device-ha ap-mode backup sync
summary
Displays the backup Zyxel Device’s synchronization settings.
show device-ha ap-mode forwarding-
port interface_name
If you apply Device HA on a bridge interface on a backup Zyxel Device, you
can use this command to see which port in the bridge interface is chosen to
receive VRRP packets used to monitor if the master Zyxel Device goes down.
interface_name: This is a bridge interface, For example, brx.
show device-ha mode
Displays whether this Zyxel Device is in active-passive mode.
Table 241 device-ha ap-mode Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
