Chapter 63 System
ZyWALL Series CLI Reference Guide
523
sms-service provider email-to-sms
Enters email-to-SMS subcommand mode.
provider-domain domain_name
Sets the domain name of your SMS service provider. The domain
name can be of up to 252 characters.
auto-append
Adds the domain name of your SMS service provider after the
receiver’s mobile phone number.
mail-subject mail-subject
Sets the subject line of up to 128 characters for outgoing e-mail
from the Zyxel Device.
mail-from user@domainname
Sets the sender’s email address of up to 64 characters. This email
address needs to be in your SMS provider’s allowed sender
address list.
If you leave this field blank, the Zyxel Device will use the IP address
or domain name configured using the command, smtp-address
{ip | hostname}.
mail-to
mobile_number@provider_domain
Sets the mobile phone number of up to 80 characters. You can
only have one receiver.
Use this variable in brackets [$mobile_number$], and the Zyxel
Device will use the mobile phone number of the user logging in.
Use the command, username username phone phone_number,
to add a valid mobile telephone number for a user.
no {provider-domain|auto-
append|mail-subject|mail-
from|mail-to}
Clears the settings.
sms-service test-send phone
phone_number msg message
Specifies the mobile phone number and message to test whether
the Zyxel Device can use SMS to send a text message.
show sms-service
Displays the SMS settings.
show sms-service activation
Displays whether the SMS service is enabled.
show sms-service default-country-
code
Displays the default country code for the mobile phone number
to which you want to send SMS messages.
show sms-service provider vianett
Displays the ViaNett account information.
show sms-service provider email-
to-sms
Displays the settings of the SMS service provider you use.
Table 299 sms-service Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
