Chapter 6 AP Management
ZyWALL Series CLI Reference Guide
60
slot_name wireless-bridge
{enable | disable}
Enables or disables wireless bridging on the specified radio
(slot_name). The radio should be in repeater mode. VLAN
and bridge interfaces are created automatically according
to the VLAN settings. See Section 6.1.2 on page 58 for more
information on wireless bridge.
When wireless bridging is enabled, the managed repeater AP
can still transmit data through its Ethernet port(s) after the
ZyMesh/WDS link is up. Be careful to avoid bridge loops. See
Section 6.1.1 on page 57 for more information on different
modes.
The managed APs in the same ZyMesh/WDS must use the
same static VLAN ID.
antenna config slot_name chain3
{ceiling | wall}
Adjusts coverage depending on each radio’s antenna
orientation.
[no] antenna sw-control enable
Enables the adjustment of coverage depending on the
orientation of the antenna for the AP radios using the web
configurator or the command line interface (CLI),
The no command disables adjustment through the web
configurator or the command line interface (CLI).
ap-group-profile ap-group-
profile_name
Sets the AP group to which the AP belongs.
description ap_description
Sets the description for the specified AP.
[no] force vlan
Sets whether or not the Zyxel Device changes the AP’s
management VLAN to match the one you configure using
the vlan sub-command. The management VLAN on the Zyxel
Device and AP must match for the Zyxel Device to manage
the AP.
This takes priority over the AP’s CAPWAP client commands
described in Chapter 73 on page 603.
lan-provision lan_port {activate
| inactivate} pvid <1..4094>
Sets the Zyxel Device to enable or disable the specified LAN
port on the AP and configures a PVID (Port VLAN ID) for this
port.
lan_port: the name of the AP’s LAN port (lan1 for example).
lan-provision vlan_interface
{activate | inactivate} vid
<1..4094> join lan_port {tag |
untag} [lan_port {tag | untag}]
[lan_port {tag | untag}]
Sets the Zyxel Device to create a new VLAN or configure an
existing VLAN. You can disable or enable the VLAN, set the
VLAN ID, assign up to three ports to this VLAN as members and
set whether the port is to tag outgoing traffic with the VLAN
ID.
vlan_interface: the name of the VLAN (vlan1 for example).
[no] override-full-power
activate
Forces the AP to draw full power from the power sourcing
equipment. This improves performance in cases when a PoE
injector that does not support PoE negotiation is used.
Use the no command to disable this feature.
[no] load-balancing <group1 |
group2> group_name
Assigns a load balancing group to the AP.
Use the no command to remove the group1 or group2
assignment of the AP.
[no] override slot_name {output-
power | radio-setting | ssid-
setting}
Sets the Zyxel Device to overwrite the AP’s output power,
radio or SSID profile settings for the specified radio.
Use the no command to not overwrite the specified settings.
Table 14 Command Summary: AP Management (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
