ZyXEL Communications ZyWALL 310 - Page 73

Chapter 8 AP Group
ZyWALL Series CLI Reference Guide
73
ap-group-member
ap_group_profile_name [no] member
mac_address
Specifies the MAC address of the AP that you want to apply the
specified AP group profile and add to the group.
Use the no command to remove the specified AP from this
group.
[no] ap-group-profile
ap_group_profile_name
Enters configuration mode for the specified AP group profile. Use
the no command to remove the specified profile.
[no] slot_name ap-profile
radio_profile_name
Sets the specified radio to work as an AP and specifies the radio
profile the radio is to use.
Use the no command to remove the specified profile.
[no] slot_name monitor-profile
monitor_profile_nameliInterval
Sets the specified radio to work in monitor mode and specifies
the monitor profile the radio is to use.
Use the no command to remove the specified profile.
[no] slot_name output-power
wlan_power
Sets the output power (between 0 to 30 dBm) for the radio on
the AP that belongs to this group.
Use the no command to remove the output power setting.
[no] slot_name ssid-profile
<1..8> ssid_profile_name
Sets the SSID profile that is associated with this profile.
You can associate up to eight SSID profiles with an AP radio.
Use the no command to remove the specified profile.
[no] slot_name repeater-ap
radio_profile_name
Sets the specified AP radio to work as a repeater and specifies
the radio profile the radio is to use.
Use the no command to remove the specified profile.
[no] slot_name root-ap
radio_profile_name
Sets the specified radio to work as a root AP and specifies the
radio profile the radio is to use.
A root AP supports the wireless connections with other APs (in
repeater mode) to form a ZyMesh to extend its wireless network.
Use the no command to remove the specified profile.
[no] slot_name zymesh-profile
zymesh_profile_name
Sets the ZyMesh profile the radio (in root AP or repeater mode)
uses to connect to a root AP or repeater.
Use the no command to remove the specified profile.
description description
Sets a description for this group. You can use up to 31 characters,
spaces and underscores allowed.
Use the no command to remove the specified description.
exit
Exits configuration mode for this profile.
[no] force vlan
Sets the Zyxel Device to change the AP’s management VLAN to
match the configuration in this profile.
Use the no command to not change the AP’s management
VLAN setting.
[no] lan-provision model
{nwa5301-nj | wac6502d-e |
wac6502d-s | wac6503d-s |
wac6553d-e} ap_lan_port
activate pvid <1..4094>
Sets the model of the managed AP and enable the model-
specific LAN port and configure the port VLAN ID.
Use the no command to remove the specified port and VLAN
settings.
ap_lan_port: the Ethenet LAN port on the managed AP, such
as lan1 or lan2.
Table 19 Command Summary: AP Group (continued)
COMMAND DESCRIPTION