Chapter 8 AP Group
ZyWALL Series CLI Reference Guide
75
[no] load-balancing [slot1 |
slot2] kickout
Enables an overloaded AP to disconnect (“kick”) idle clients or
clients with noticeably weak connections.
load-balancing [slot1 | slot2]
liInterval <1..255>
Sets the interval in seconds that each AP communicates with the
other APs in its range for calculating the load balancing
algorithm.
Note: This parameter has been optimized for the Zyxel
Device and should not be changed unless you
have been specifically directed to do so by Zyxel
support.
load-balancing [slot1 | slot2]
max sta <1..127>
If load balancing by the number of stations/wireless clients, this
sets the maximum number of devices allowed to connect to a
load-balanced AP.
load-balancing mode [slot1 |
slot2] {station | traffic |
smart-classroom}
Enables load balancing based on either number of stations (also
known as wireless clients) or wireless traffic on an AP.
station or traffic: once the threshold is crossed (either the
maximum station numbers or with network traffic), the AP delays
association request and authentication request packets from
any new station that attempts to make a connection.
smart-classroom: the AP ignores association request and
authentication request packets from any new station when the
maximum number of stations is reached.
load-balancing [slot1 | slot2]
sigma <51..100>
Sets the load balancing sigma value.
This value is algorithm parameter used to calculate whether an
AP is considered overloaded, balanced, or underloaded. It only
applies to ‘by traffic mode’.
Note: This parameter has been optimized for the Zyxel
Device and should not be changed unless you
have been specifically directed to do so by Zyxel
support.
load-balancing [slot1 | slot2]
timeout <1..255>
Sets the length of time that an AP retains load balancing
information it receives from other APs within its range.
load-balancing [slot1 | slot2]
traffic level {high | low |
medium}
If load balancing by traffic threshold, this sets the traffic threshold
level.
vlan <1..4094> {tag | untag}
Sets the management VLAN ID for the AP(s) in this group as well
as whether packets sent to and from that VLAN ID are tagged or
untagged.
show ap-group first-priority
Displays the name of the default AP group profile.
show ap-group-profile {all |
ap_group_profile_name}
Displays the settings of the AP group profile(s).
all: Displays all profiles.
ap_group_profile_name: Displays the specified profile.
show ap-group-profile
ap_group_profile_name load-
balancing config
Displays the load balancing configuration of the specified AP
group profile.
Table 19 Command Summary: AP Group (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
