Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
99
The following table describes the commands available for ZyMesh profile management. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 30 Command Summary: ZyMesh Profile
COMMAND DESCRIPTION
show zymesh ap info
Displays the number of currently connected/offline ZyMesh APs.
show zymesh link info {repeater-
ap | root-ap}
Displays the ZyMesh/WDS traffic statistics between the managed
APs.
repeater-a: the managed AP is acting as a repeater in a
ZyMesh.
root-ap: the managed AP is acting as a root AP in a ZyMesh.
show zymesh provision-group
Displays the current ZyMesh Provision Group MAC address in the
Zyxel Device.
show zymesh-profile {all |
zymesh_profile_name}
Displays the ZyMesh profile settings.
all: Displays all profiles.
zymesh_profile_name: Displays the specified profile.
zymesh-profile rename
zymesh_profile_name1
zymesh_profile_name2
Gives an existing radio profile (zymesh_profile_name1) a new
name (zymesh_profile_name2).
[no] zymesh-profile
zymesh_profile_name
Enters configuration mode for the specified ZyMesh profile. Use
the no parameter to remove the specified profile.
psk psk
Sets a pre-shared key of between 8 and 63 case-sensitive ASCII
characters (including spaces and symbols) or 64 hexadecimal
characters.The key is used to encrypt the wireless traffic between
the APs.
ssid ssid
Sets the SSID with which you want the managed AP to connect to
a root AP or repeater to build a ZyMesh link.
Note: The ZyMesh SSID is hidden in the outgoing beacon
frame so a wireless device cannot obtain the SSID
through scanning using a site survey tool.
exit
Exits configuration mode for this profile.
zymesh provision-group ac_mac
Enters the ZyMesh Provision Group MAC address of the primary AP
controller in your network to use this Zyxel Device to replace the
primary AP controller.
To Next Page
Loading...
