10
Accutome B-Scan Plus User Guide
Do not completely immerse the probe and cable. Only
the probe tip of the B-Scan Plus should be placed in the
solution.
Do not immerse the connectors.
Do not autoclave the probe or the cable.
After cleaning, rinse the end of the probe thoroughly with
distilled water to remove all traces of the liquid used.
Follow the instructions on the label of the disinfectants.
The surfaces should then be dried with a lint-free cloth.
Disinfection issues are confin
ed to the probe tip that
comes in contact with the patient’s eye. In order to
prevent the transmission of disease, refer to the OSHA
and CDC guidelines for proper control of disinfection.
These guidelines are frequently updated so be sure to
contact OSHA, CDC, or your local disease control for the
latest information and disinfection technique.
Note: Be sure to follow the ma
nufacturer's written
protocol when using any antibacterial solution, including
high level disinfectants.
WARNING! DO NOT WIPE THE PROBE
END; IT MAY RESULT IN
DAMAGE TO THE CRYSTAL.
WARNING! DO NOT IMMERSE THE
PROBE’S CABLE OR METAL
CONNECTOR. ALLOW TO
DRY BEFORE USE.
To Next Page
Loading...
