17
Getting Started Installing the Software
Installing the
Software
The Accutome B-Scan Plus software is shipped on a CD
which contains all of the programs you will need to install
for proper system operation.
PLEASE READ THROUGH ALL OF THE
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING ANY SOFT-
WARE!!
IMPORTANT:
1. DO NOT plug the Accutome Probe into the USB
port until all application software and drivers have
been installed.
2. Plug
the wireless mouse USB adapter (which is
found on the underside of the mouse) into a USB
port which will not be used for the Accutome Probe
3. T
urn your computer to "On".
4. Follow the steps below to install Accutome’s B-
Scan Plus software to a personal computer.
5. Y
our computer must have Microsoft Windows XP
SP2 and .NET Framework 1.1 installed to operate
the Accutome B-Scan Plus properly.
Installation - Phase One
Follow the steps below to check for and, if necessary,
install .NET Framework 1.1 on your computer:
1. Op
en the Control Panel window by clicking on
Start located on the bottom left corner of the win-
dow. Click on Control Pane
l located on the right
side of the pop-up menu.
2. In the Co
ntrol Panel window, click on Add or
Remove Programs. The Add or Remove
Programs window will appear on the desktop.
Scroll down the list to find Microsoft .NET
Framework 1.1 in the Currently Installed
Programs list.
To Next Page
Loading...
