35
Getting Started Basic Operation
Scanning
To capture a patient scan image:
1. Adju
st any Probe, Cine, TGC or Gamma settings
using the appropriate tab.
2. Click on "Scan" on the Probe tab, or press the
start/stop button on the probe, or step on the
footswitch to activate the image acquisition film
loop.
3. On
ce the scanning is started the B-Scan Plus
computer will store the last "X" seconds of image
data (predetermined in Setup, Cine Buffer).
4. Wh
en you stop the scanning by either using the
trigger switch on the probe, the footswitch, or by
clicking "Stop" on the Exam Screen, the Accutome
B-Scan Plus will stop the Image Acquisition film
loop. To go to the next view in the sequence you
must step on the footswitch or press the start/stop
button on the probe. The B-Scan Plus will also
create a new view in the sequence if you continue
to scan after completing all the defined sequence
steps.
*Note: For detailed information on scanning refer to
"Performing Exams" on page 89 of this manual.
How to Print an Exam
After you have acquired and analyzed a patient exam
you may want to print a portion of the exam.
To print an image of an scan:
1. With the appropriate Patient exam active, press
the "Snapshot " or "Print Image" button, located to
the right side of the image display.
2. Th
e Accutome B-Scan Plus will copy or print the
screen. Snapshots are saved as part of the patient
exam.
3. Y
ou can view and revise all snapshots for printing
in an existing exam using the "Reports" tab on the
Analyze screen.
To Next Page
Loading...
