Accutome B-Scan Plus - Cleaning of the Probe; Electrical Hazard and Safety

11
Safety Safety Precautions
CAUTION: GENERAL INDICATIONS
FOR USE OF THE
ACCUTOME PROBE
INCLUDE ON EXTERNAL
STRUCTURALLY INTACT
AREAS OF THE EYE GLOBE
AND ORBIT AREAS ONLY.
Cleaning of the Probe
Clean the probe handle with a damp cloth. Use
appropriate products to clean the computer, keyboard
and monitor. Cables may be cleaned with a soft cloth
and alcohol. The probe holder should be washed with
warm water and mild detergent.
Probe and Transducer:
The user must use the following procedure to clean the
tra
nsducer and probe daily:
Keep the transducer and probe connected, soak/rinse
th
e transducer and probe end thoroughly with distilled
water.
-Inspect all surfaces carefully for debris or build up.
-If there is still debris, soak/rinse the tra
nsducer and
probe tip end with distilled water again. Repeat until all
debris is gone.
-Let the transducer and probe air dry.
Electrical Hazard and Safety
The instrument, foot switch and probe of the Accutome
B-Scan Plus are electrical/electronic devices.
Reasonable care should be taken when making
electrical connection and handling electrically powered
devices. Avoid use of damaged electrical equipment or
frayed electrical cords. If repair or maintenance is being