20
Accutome B-Scan Plus User Guide
In the next screen, make sure Install the Software
Automatically (Recommended) is selected, then
click on Next. The system will find the driver for
the probe and the window Hardware Installation
will appear. Click Continue Anyway and then
Finish.
After the driver has been installed and all windows
are close
d, the window Found New Hardware
Wizard will reappear. You will need to repeat the
above two steps one more time to finish the probe
driver installation for this USB port.
2. W
e recommend that you install the Accutome B-
Scan Plus probe driver on at least two USB ports
in the event one port is already being used by
another device. The Accutome B-Scan Plus probe
will not work properly on any USB port on which it
has not been installed.
To install the Accutome B-Scan Plus probe on
ano
ther USB port, repeat section 1. Be sure to
unplug the probe from the current USB port and
insert it into the new USB port to start setup of the
new USB port.
3. Unp
lug the Accutome B-Scan Plus probe from the
USB port and eject the installation CD from the
CDROM drive. Reboot the computer by clicking
on Start, then Shut Down, then Restart, then OK.
4. Af
ter the computer restarts, login (if necessary) to
your account. Wait until the desktop appears, then
plug the probe into any of the USB ports that have
been set up. Wait 10 seconds after connecting the
Accutome B-Scan Plus probe, then double click
the Launch Accutome B-Scan.exe icon on the
desktop to start the Accutome B-Scan Plus
program.
Please remember that the probe must
be plugged into a USB port that has been set
up before starting the program.
To Next Page
Loading...
