By default, this mode is enabled, but it can be disabled per case by tapping or by default in the Scan
settings, as described in Defining the scan settings.
5.5.3.2 Scan color toggle
The color toggle button allows you to toggle between color and monochromatic modes. This applies to both
scanning and viewing all case types.
Figure 109: Model displayed in color and monochrome mode
By default, models are scanned in color, but you can toggle the display per case by tapping or by default in
the Scan settings, as described in Defining the scan settings.
5.5.3.3 Switching to the next scan segment
During scanning, the current segment is highlighted in blue in the navigation controls, and also displayed in the
segment indicator box, between the arrows.
Note: Before moving to the next segment, press either of the wand buttons to stop the wand from scanning.
iTero Element 5D and iTero Element 5D Plus imaging systems User manual
110 © 2022 Align Technology, Inc. All rights reserved.
To Next Page
Loading...