11..22 10G Multirate Module10G Multirate Module
The 10G Multirate module (MU100010A) allows the Network Master to test a
large variety of interfaces and systems up to 10 Gbps, like OTN interfaces,
Ethernet interfaces, SDH/SONET interfaces, Fibre Channel interfaces and
PDH/DSn interfaces. The MU100010A can be configured to have two ports at
all rates and interfaces. The instrument is thus ideal for both in-service and out-
of-service transmission-quality measurement.
For fast troubleshooting, the Network Master displays alarms and transmission
link status on Lamp icons in its display. The instrument's two ports permit
immediate monitoring of the two sides of a line and allow comparison of
simultaneously recorded results.
11..33 100G Multirate Module100G Multirate Module
The 100G Multirate module (MU100011A) allows the Network Master to test
systems in interfaces bit rate of up to 10 Gbps, 25 Gbps, 40 Gbps, and 100
Gbps by using SFP+, SFP28, QSFP, and CFP4 optical transceivers
Supported InterfacesSupported Interfaces
InterfaceInterface MU100010AMU100010A MU100011AMU100011A
10BASE-T, 100BASE-TX, 1000BASE-T ✓ ✓
100BASE-XX, 1000BASE-XX,
10GBASE-XX
✓ ✓
25GbE, 40GbE, 100GbE - ✓
SDH-1/4/16/64, OC-3/12/48/192 ✓ ✓
E1, E3, E4, DS1/J1, DS3,
SDH-1e, STS-3
✓ -
OTU-1/1e/1f/2/2e/2f ✓ ✓
OTU-3/3e1/3e2/4 - ✓
FC100, FC200, FC400, FC800, FC1200 ✓ ✓
FC1600 - ✓
CPRI-1/2/3/4/5/6/7/8,
OBSAI (768, 1536, 3072, 6144 Mbps)
✓ ✓
✓: Supported, -: Not Supported
In a module configuration that uses a 100G Multirate module in combination
with an OTDR module, CPRI module or other modlues, MT1000A-006 high
power supply is required for MT1000A even when measurement function of
MU100011A is not used.
To Next Page
Loading...
