Input modeInput mode
FollowsFollows
This screen allows you to make the physical setup of the PDH receiver in DS3
mode. It can also be used to inspect the current status of the selected port.
The configuration options available in the setup area of the screen are
described below. The status information is described in a separate section.
Select the mode of input.
TerminateTerminate
Used when the instrument is used as a tester and the receiver is the only
device connected to the line. The input impedance is nominal.
MonitorMonitor
Used when connecting to protected monitoring points. The input impedance
is nominal.
55..66..22..22 DS3 Signal SetupDS3 Signal Setup
Touching the navigation area button which represents the receiver's DS3 layer
will display the screen shown below.
To make the currently selected receiver follow either the transmitter or Port 1
receiver (i.e. copy its settings), touch the drop-down menu in the navigation
area and select the relevant value. The receiver settings continue to follow the
change of either the transmitter or Port 1 receiver. The default setting is NoneNone.
Note that the Port 1 receiver cannot follow the Port 2 receiver.
PCM framePCM frame
Use the PCM framePCM frame radio buttons to enable (OnOn) or disable (OffOff) the status of
the PCM frame.
Frame typeFrame type
Use the Frame typeFrame type radio buttons to specify either an M13M13 frame or a C-BitC-Bit
frame.
Pattern typePattern type
Select the requested pattern. Available patterns are the same as the transmitter
setup. Refer to Pattern type in "E1 Setup and Status".
To Next Page
Loading...
