When EthernetEthernet is selected on 'Threshold' of the Test Setup screen, the EthernetEthernet
information appears in the upper right-hand corner, shows pass/fail status
summary. Touching the DetailsDetails button allows you to inspect the individual
pass/fail status.
TransportTransport
Displays the results of Transport test. This result appears if 'Transport' check
box is selected in the Test Setup screen.
The stream slide-up at the bottom of the screen allows you to configure and
inspect the measurements of each individual stream. Display/Hide the slide-up
by touching the handle icon. You can set up thresholds for frameloss, latency
and jitter for each stream as well as inspect the measurement results.
66..55..33..22 IEEE1588v2 LogIEEE1588v2 Log
If Ext. logExt. log is selected in IEEE1588v2 screen of Ethernet Frame Setup, the
IEEE1588v2 LogIEEE1588v2 Log button appears in the navigation area. Refer to IEEE1588v2
Log in "BERT" for the operation.
To Next Page
Loading...
