Only available if you have specified a Frame Loss test on the 'Control' of the
Test Setup screen.
Touching the Frame lossFrame loss button in the navigation area will display the screen
shown below.
This screen allows you to configure the following parameters related to an RFC
2544 Frame Loss test:
Frame Size
Line Load
Duration
The parameters are identical to the ones described in the
Throughput
section
above.
66..99..22..44 Throughput and Frame LossThroughput and Frame Loss
Only available if you have specified a 'Throughput and Frame Loss' test on the
'Control' of the Test Setup screen. Use this test if you want to perform both a
Throughput test and a Frame Loss test while using the same test parameters for
both.
Touching the Throughput and frame lossThroughput and frame loss button in the navigation area will
launch the screen shown below.
To Next Page
Loading...
