Test resultsTest results
The results are presented in a table and are related to a specific CIR% (CIR
25.00%, CIR 50.00%, CIR 75.00%, and CIR 100%). Select the relevant CIR%
either by selecting the corresponding bar in the bar graph or by using the CIR
drop-down menu.
Touching a cell in table displays Minimum, Maximum, Mean value and the
Threshold, at bottom of screen.
Select a cell in the results table to see the details. The following information is
presented:
IR / ULRIR / ULR
Shows the minimum, mean and maximum bit rate in Mbps. Depending on the
test setup, the bit rate is either Information Rate (IR) or Utilized Line Rate
(ULR).
FLFL
Shows the number of lost frames and the frame loss ratio. The frame loss ratio
is frames lost divided by frames transmitted.
FTD / RT FTDFTD / RT FTD
Shows the minimum, mean, maximum and current Frame Transfer Delay in
milliseconds. Depending on the test setup, the result is either one-way delay or
round-trip delay.
FDV / RT FDVFDV / RT FDV
Shows the minimum, mean, maximum and current Frame Delay Variation in
milliseconds. Depending on the test setup, the result is either one-way or
round-trip.
66..1111..33..33 Performance TestPerformance Test
Selecting the Performance TestPerformance Test button in the navigation area will display the
screen shown below.
This screen presents the detailed Performance Test results.
To Next Page
Loading...
