Avaya CU360 - Network Security Features; 802.1 x (PNAC) and 802.1 q (VLAN) for Ethernet

• Power adapter
• Rubber cap for camera
USB-C
HDMI
Reset
USB-A
Ethernet
Power Supply
Micro SD
On/Off Button
Kensington lock
NFC
Procedure
1. Secure the Avaya CU360 endpoint on an external monitor using the hinge at the bottom of
the endpoint.
2. Connect the HDMI cable in the HDMI ports of Avaya CU360 and the external monitor.
3. Connect the power adapter.
Switching Avaya CU360 on or off
About this task
The power button of Avaya CU360 on the rear of the device. You can use the power button to:
• Switch Avaya CU360 on or off.
• Change the Avaya CU360 mode to standby or wake up the device from the standby mode.
Procedure
Do one of the following:
• To switch Avaya CU360 on or off, press and hold the power button.
• To change the mode of Avaya CU360 to standby or wake up the device from the standby mode,
press the power button.
Switching Avaya CU360 on or off
October 2022 Installing and Administering Avaya Collaboration Unit CU360 35
Comments on this document? infodev@avaya.com