Avaya CU360 - Documentation and Support; Additional References

USB Type-A
USB Type-C
Avaya CU360
USB Type-C
Before you begin
Connect the USB 3.0 cable to the USB-C port of the Avaya CU360 endpoint.
Procedure
Connect the Avaya CU360 endpoint to the computer.
Result
• The computer automatically detects the Avaya CU360 endpoint.
• Avaya CU360 displays Computer detected on USB Press 'Control Camera' to
activate USB bar Mode message.
• Avaya CU360 displays the USB Bar Mode icon on the top of the information bar.
• Avaya CU360 changes the control camera icon on the home page.
Related links
Avaya USB AV bar on page 30
Customizing Avaya CU360 for USB AV bar mode
About this task
Manually activate the USB AV bar mode from Avaya CU360 after connecting to the laptop or
computer.
Enable the Always Active option if you need to use the Avaya CU360 endpoint only in USB AV Bar
Mode without connecting any monitor.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
Customizing Avaya CU360 for USB AV bar mode
October 2022 Installing and Administering Avaya Collaboration Unit CU360 97
Comments on this document? infodev@avaya.com