Avaya CU360 - General Troubleshooting; Common Troubleshooting

Configuring the Avaya CU360 video layout in meetings
About this task
After you connect the single monitor or dual monitor to the Avaya CU360 endpoint, you can
configure the video layouts.
You can also change the video layout from the Avaya CU360 remote control during the meetings.
Procedure
1. Do one of the following:
• On the endpoint, click .
• On the web interface, click More Actions.
2. On the endpoint, click Participants.
Avaya CU360 displays the Participants window.
3. Click Layouts.
Result
• If you connect a single monitor, Avaya CU360 displays the video layouts for a single monitor.
• If you connect dual monitor, Avaya CU360 displays the video layouts for dual monitor.
Related links
Avaya CU360 supports additional monitor on page 29
Avaya CU360 remote control unit on page 16
Configuring the USB AV bar mode in Avaya CU360
About this task
Manually activate the USB AV bar mode from Avaya CU360 after connecting to the laptop or
computer.
Enable the Always Active option if you need to use the Avaya CU360 endpoint only in USB AV Bar
Mode without connecting any monitor.
Procedure
1. Do one of the following:
• On the endpoint home page, click Configure.
• On the web interface, click Basic Settings.
2. Click Quick Setup.
3. Select USB Bar Mode.
Configuring the Avaya CU360 video layout in meetings
October 2022 Installing and Administering Avaya Collaboration Unit CU360 95
Comments on this document? infodev@avaya.com