Avaya CU360 - Configuring Avaya CU360 for port-based network authentication

• Password: Users must enter a password to be allowed to install applications.
Configuring Avaya CU360 for port-based network
authentication
About this task
Configure the network security authentication for IEEE 802.1X-compliance over the Ethernet.
This configuration is available only on the Avaya CU360 endpoint.
Before you begin
Ensure that your network components support IEEE 802.1Q.
Important:
If the components do not support IEEE 802.1Q, and if you enable this feature, Avaya CU360
will not get an IP address.
Procedure
1. Click on the navigation bar.
Avaya CU360 displays the desktop.
2. Click .
3. Click Settings.
Avaya CU360 displays the Settings window.
4. Click More.
Avaya CU360 displays the Wireless & networks window.
5. Click Ethernet.
Avaya CU360 displays the Ethernet window.
6. Click 802.1X (PNAC).
Avaya CU360 displays the Ethernet 802.1X (PNAC) window.
7. Configure the following fields:
• Enable: Select Yes.
• Authentication: Select MD5.
• Username: Type the username for 802.1X-compliant authentication.
• Password: Type the password for 802.1X-compliant authentication.
8. Click Save.
Initial administration
October 2022 Installing and Administering Avaya Collaboration Unit CU360 84
Comments on this document? infodev@avaya.com