Avaya CU360 - Software Upgrade Methods; Upgrade via USB key - Automatic Mode; Upgrade via Web - Automatic Mode

Configuring Wi-Fi network connectivity from the Avaya
CU360 endpoint
About this task
To connect Avaya CU360 to the Wi-Fi network, you must select the Wi-Fi network and enter the
credentials and authentication type.
This configuration is available only on the Avaya CU360 endpoint.
Important:
Do not connect Ethernet and Wi-Fi networks simultaneously in Avaya CU360.
Note:
You can permanently disable Wi-Fi on Avaya CU360 using a license. You can use this option
in networks that restrict wireless connectivity for security. Disabling Wi-Fi also disables Wi-Fi
Display.
Before you begin
Ensure that the Ethernet cable is not connected to Avaya CU360.
Procedure
1. Click Configure > Networks.
2. Click Wi-Fi.
Avaya CU360 displays the Wi-Fi window.
3. Enable Wi-Fi.
4. Select and configure your Wi-Fi network.
If you do not need to install security certificates for your Wi-Fi network, set CA Certificate
to Do Not Validate.
Configuring Wi-Fi network connectivity from the Avaya
CU360 web interface
About this task
To connect Avaya CU360 to the Wi-Fi network, you must select the Wi-Fi network and enter the
credentials and authentication type.
This configuration is available only on the Avaya CU360 web interface.
Important:
Do not connect Ethernet and Wi-Fi networks simultaneously in Avaya CU360.
Configuring Wi-Fi network connectivity from the Avaya CU360 endpoint
October 2022 Installing and Administering Avaya Collaboration Unit CU360 73
Comments on this document? infodev@avaya.com