Note:
You can permanently disable Wi-Fi on Avaya CU360 using a license. You can use this option
in networks that restrict wireless connectivity for security. Disabling Wi-Fi also disables Wi-Fi
Display.
If you connect the Avaya CU360 web interface using the IP Address through a Wi-Fi network then
changing the Wi-Fi network or disconnecting causes the web session to end. A warning message
displays on the same web browser.
Before you begin
Ensure that the Ethernet cable is not connected to Avaya CU360.
Procedure
1. On the web interface, click Administrator Settings.
2. Click Networks > Wi-Fi > Addresses.
Avaya CU360 displays the Wi-Fi window.
3. Select Yes to enable the Use Wi-Fi option.
4. Select and configure your Wi-Fi network.
Configuring Bluetooth connectivity in Avaya CU360
About this task
This configuration is available only on the Avaya CU360 endpoint.
Note:
You can permanently disable Bluetooth on Avaya CU360 using a license. You can use this
option in networks that restrict wireless connectivity for security.
Before you begin
Enable the Avaya CU360 advanced settings.
Procedure
1. Select Configure.
Avaya CU360 displays the Configure window.
2. Select Advanced.
The default PIN is 1234.
If your administrator configures a PIN to access the advanced settings, Avaya CU360
prompts you to enter the PIN. After entering the PIN, Avaya CU360 displays the Advanced
window.
3. Click System.
Initial administration
October 2022 Installing and Administering Avaya Collaboration Unit CU360 74
Comments on this document? infodev@avaya.com
To Next Page
Loading...
