1 Local Basic Operation
Slight difference may be found on the user interface. The following figures are for reference
only.
1.1 Getting Started
This chapter introduces device initial settings such as boot up, device initialization, reset
password, and quick settings.
1.1.1 Booting up
● For device security, connect the NVR to the power adapter first and then connect the device
to the power socket.
● The rated input voltage matches the device power button. Make sure the power wire
connection is OK. Then click the power button.
● Always use the stable current, if necessary UPS is a best alternative measure.
Step 1 Connect the device to the monitor and then connect a mouse.
Step 2 Connect power cable.
Step 3 Click the power button at the front or rear panel and then boot up the device.
After device booted up, the system is in multiple-channel display mode by default.
Copyright © NSS Sp. z o.o.
1 User‘s Manual
To Next Page
Loading...
General