BCS Line - Fall Detection; People Exception Detection

113
Step 2 Select a channel and click
Add
.
Step 3 Select
Enable
and set
Type
to
People Approach Detection
.
Step 4 Click , and then click and hold left mouse key to draw an area on the screen.
Step 5 Configure parameters.
Table 4-30
Parameter Description
Sensitivity Set alarm sensitivity.
Duration
Set the minimum time of triggering an alarm when people
approach.
Repeat Alarm Time
Set repeat alarm time. If the alarm status continues, an alarm will
be trigger again when repeat alarm time is reached.
Interval Threshold
When the interval between people in the area is greater than or
less than the set interval threshold, an alarm will be triggered.
Step 6 Click
OK
.
1.7.1.4.2 Fall Detection
When someone falls from a height in the detection area and the duration of the action is greater
than the minimum duration set by the parameter, an alarm will be triggered.
Step 1 Select
Main Menu
>
AI
>
Parameters
>
Stereo Analysis
.
Step 2 Select a channel and click
Add
.
Step 3 Select
Enable
and set
Type
to
Fall Detection
.
Step 4 Click , and then click and hold left mouse key to draw an area on the screen.
Step 5 Configure parameters.
Table 4-31
Parameter Description
Sensitivity Set alarm sensitivity.
Duration Set the minimum time of triggering an alarm when people fall.
Repeat Alarm Time
Set repeat alarm time. If the alarm status continues, an alarm will
be trigger again when repeat alarm time is reached.
Step 6 Click
OK
.
1.7.1.4.3 People Exception Detection
When the number of people and alarm type are reached in the same detection area, an alarm
will be triggered.
Step 1 Select
Main Menu
>
AI
>
Parameters
>
Stereo Analysis
.
Step 2 Select a channel and click
Add
.
Step 3 Select
Enable
and set
Type
to
People Exception Detection
.
Step 4 Click , and then click and hold left mouse key to draw an area on the screen.
Step 5 Configure parameters.
Table 4-32
Parameter Description
Sensitivity Set alarm sensitivity.
Copyright © NSS Sp. z o.o.
113 User‘s Manual