EasyManuals Logo

BCS Line User Manual

BCS Line
329 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #270 background imageLoading...
Page #270 background image
259
NTP Server
is enabled.
Table 4-84 Basic service parameters
Parameter Description
Mobile Push
Notifications
After enabling this function, the alarm triggered by the NVR can
be pushed to a mobile phone. This function is enabled by
default.
CGI
If this function is enabled, the remote devices can be added
through the CGI protocol. This function is enabled by default.
ONVIF
If this function is enabled, the remote devices can be added
through the ONVIF protocol. This function is enabled by default.
NTP Server
After enabling this function, a NTP server can be used to
synchronize the device. This function is enabled by default.
SSH
After enabling this function, you can use SSH service. This
function is disabled by default.
Enable Device
Discovery
After enabling this function, the NVR can be found by other
devices trough searching.
Private Protocol
Authentication Mode
Security Mode (Recommended): Uses Digest access
authentication when connecting to NVR.
Compatible Mode: Select this mode when the client does not
support Digest access authentication.
Step 3 Click
Apply
to complete the settings.
1.14.2.2 802.1x
The device needs to pass 802.1x certification to enter the LAN.
Step 1 Select
Main Menu
>
SECURITY
>
System Service
>
802.1x
.
The
802.1x
interface is displayed. See Figure 4-269
Copyright © NSS Sp. z o.o.
259 User‘s Manual

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BCS Line and is the answer not in the manual?

BCS Line Specifications

General IconGeneral
BrandBCS
ModelLine
CategoryDVR
LanguageEnglish