Bosch Rexroth Tightening System 350 - Page 341

3 608 878 300 Tightening Technology | Bosch Rexroth AG 341/641
System 350 | 3 608 878 300/2019-03
6.7.7.2 Available KE messages
The following messages are supported by the KE350 Open Protocol:
MID 0555
3)
Upload last job results data response
xx
MID 0556
3)
Last job results data acknowledgement
xx
MID 0557
3)
Cancel last job results data
xx
MID 0570
1
Activate job
xx
MID 0571
1
Start job sequence
xx
MID 0573
1
Select job number
xx
MID 9999 Keep alive message
xxx
1 This message is supported as of version V2.300 of the Rexroth Tightening System 350.
2 Is supported, but does not have any function
3 This message is supported as of version V2.400 of the Rexroth Tightening System 350.
4 This message is supported as of version V2.500 of the Rexroth Tightening System 350.
Table 6–74: Available CS351 messages
MID Description Rexroth
OP
Rexroth
OP-Ford
Rexroth
OP-BMW
The "Rexroth OP-Ford" Open Protocol is available from firmware version 2.300.
Activation for applications is only possible for application block 1 (FO1). Single channels cannot be
activated.
To meet special customer requirements, activation by Open Protocol can be further processed via the
integrated logic (IL). Under System  Tightening cell data  Open Protocol, select the Forward I/O
signals to IL function and create a respective IL program.
Table 6–75: Available KE messages
MID Description Rexroth
OP-Ford
Rexroth
OP
MID 0001
1
)
Communication start
xx
MID 0002
1)
Acknowledgement of communication start
xx
MID 0003
1)
Communication stop
xx
MID 0004
1)
Command error
xx
MID 0005
1)
Command accepted
xx
MID 0006 Spindle connection status
x
MID 0007 Acknowledgement of spindle connection status
x
MID 0008 Spindle connection status subscription
x
MID 0009 Cancel spindle connection status subscription
x
MID 0010
1)
Request to upload tightening program/tightening application numbers
xx
MID 0011
1)
Response to upload of tightening program/tightening application numbers
xx
MID 0012
1)
Tightening program data upload request
x
MID 0013
1)
Tightening program data upload response
x
MID 0014 Subscription to tightening program/tightening application selected
x
MID 0015 Tightening program/tightening application selected
x
MID 0016 Acknowledge tightening program/tightening application selected
x
MID 0017 Cancel subscription to tightening program/tightening application selected
x
MID 0018 Select tightening program/tightening application
x
MID 0030 OK counter upload request
x
MID 0030
1)
Job number upload request
x
MID 0031
1)
OK counter upload response
x