Operation
122
Instructions for use Primus Infinity Empowered SW 4.5n
Disposable absorber Drägersorb CLIC
The appropriate adapter must be installed by
trained personnel, e.g., DrägerService.
Remove the spent absorber
1 Press the button (A): the mounting swings open
sealing the breathing system so that the ventila-
tion can continue.
If the absorber is replaced during ventilation, the in-
spiratory gas concentrations can drop for a short
period.
2 Slide the disposable absorber off the mount (B).
3 Dispose of the spent absorber.
Refer to the instructions for use of the Drägersorb
CLIC absorber for information on disposal.
Install the new absorber
1 Before fitting, shake the disposable absorber,
e.g., by turning it upside down several times in
order to loosen up the soda lime.
2 Remove the seal from the new disposable ab-
sorber.
3 Slide the new disposable absorber into the
mount (B) and
4 Push the absorber into the machine (B) until it
engages.
If the Infinity ID CLIC absorber has been configured
in Standard Conf. (see "Soda lime depletion"
on page 80), the new absorber will be automatically
detected by Primus Infinity Empowered.
If the Infinity ID CLIC absorber was not configured:
z Reset the soda lime change log to current date
by pressing the soft key soda lime changed,
see page 88.
NOTE
The disposable CO2 absorber must be clicked
into place before Primus Infinity Empowered is
switched on. This ensures that the absorber is in-
cluded in the leak and compliance test of the ma-
chine.
093
A
B
WARNING
Risk of increased inspiratory CO2 concentra-
tions
When the absorber is swung out, no CO2 is ab-
sorbed.
Always make sure the absorber is clicked into
place after installing or replacing.
To Next Page
Loading...
